Kenwood KSC-SW10 Instruction Manual

Also see for KSC-SW10: Training guide Product information Instruction manual

Contents

ENGLISH8 English1 Turn the FREQUENCY control knob to adjust thecut-off frequency (frequencies higher than thisfrequency are cut off).2 Turn the LEVEL control knob to adjust the lowfrequencies to the desired level.3 Adjust the low frequency phase.The low frequency tone may be variable depending on the po-sition of the unit, its orientation or the turn-over frequency. Thiscan be adjusted by changing the position of the PHASE switch.Set this switch to either position according to your liking.[[0°] indicates the normal phase and [180°] means the reversephase.OperationName of each part (Remote control)PHASE switch(Phase select switch)FREQUENCY control knob(Cut-off frequency control knob)LEVEL control knob(Input sensitivity control knob)Power indicator(Power display light)Power indicatorRed glowsPower ONLight is OFFPower OFFIlluminationThe illumination on the subwoofer turns on and offin an interlocked operation with the PWR indicatoron the remote control unit.FREQUENCYLEVELLOW HIGHMINMAXAdjusting the sound (Remote control operation)Turn the FREQUENCY control knob to adjust the balance between thebass from the rear speakers and the bass from this unit as desired.Fuse exchangeExchange with the specified capacity fuse.Removal InsertionFuse CoverFuse holderReplacement fuse 10 A1 Open the cover.2 Grasp with pliers and pull up.1 Insert the fuse gently into the fuse holder andpush in all the way with your finger.2 Close the cover.Caution: Be sure to replace with same capacity (amperage) as displayed on the fuse. This product is 10A.130.com.uaAutogood products internet store http://130.com.ua

/ 10

Related manuals for Kenwood KSC-SW10