Kenwood KVT-514 Instruction Manual

Also see for KVT-514 - Wide In-Dash Monitor: Installation manual

Contents

I ACAUTIONUse of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiationexposure.In compliance with Federal Regulations, following are reproductions of labels on, or inside the product relating to laser productsafety.Kenwood Corporation2967-3, ISHIKAWA-MACHI,HACHIOJI-SHITOKYO, JAPANKENWOOD CORP CERTIFIES THIS EQUIPMENTCONFORMS TO DHHS REGULATIONS NO.21 CFR1040. 10, CHAPTER 1, SUBCHAPTER 1.Location: Bottom PanelFCC WARNINGThis equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmfulinterference unless the modifications are expressly approved in the instruction manual. The user could lose the authority tooperate this equipment if an unauthorized change or modification is made.NOTEThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of theFCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with theinstructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment doescause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, theuser is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radiolTV technician for help.The "AAC" logo is a trademark of Dolby Laboratories.iPod is a trademark of Apple Inc, registered in the U.s. and other countries.iPhone is a trademark of Apple Inc."Made for iPod" means that an electronic accessory has been designed to connect specifically to iPod and has been certifiedby the developer to meet Apple performance standards."Works with iPhone" means that an electronic accessory has been designed to connect specifically to iPhone and has beencertified by the developer to meet Apple performance standards.Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.~ is a trademark of DVD Format/Logo Licensing Corporation registered in the U.s., Japan and other countries.This product incorporates copyright protection technology that is protected by U.s. patents and other intellectual propertyrights. Use of this copyright protection technology must be authorized by Macrovision, and is intended for home and otherlimited viewing uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited.Manufactured under license from Dolby Laboratories."Dolby" and the double-D symbol are trademarks of Dolby Laboratories.Manufactured under license under U.s. Patent #'s: 5,451,942; 5,956,674; 5,974,380; 5,978,762; 6,487,535 & other U.S. andworldwide patents issued & pending. DTS and DTS 2.0 + Digital Out are registered trademarks and the DTS logos and Symbolare trademarks of DTS, Inc. ©1996-2007 DTS, Inc. All Rights Reserved.