Kenwood NEXEDGE NX-240 Instruction Manual

Also see for NEXEDGE NX-240: Instruction manual Function reference

Contents

2PREPARATIONINSTALLING THE CHANNEL STOPPERYou can set the channel stopper position for channels 2, 4,6, 8, 10, 12, and 14. Inserting the Channel stopper preventsunnecessarily selecting channels which do not exist.• Selecting a channel which does not exist causes a continuous errortone to sound.1 Set the Channel selector to channel 1, then pull theChannel selector knob off the transceiver.• If the Channel selector is not positioned at channel 1, the knob maynot install correctly and the channel may be unable to change.2 Insert the channel stopper.3 Set the arrow of the Channel stopper to the highest channelnumber for the transceiver.4 Reinsert the Channel selector knob.Screw the antenna into the connector on thetop of the transceiver by holding the antenna atits base and turning it clockwise until secure.Note: The antenna is neither a handle, akey ring retainer, nor a speaker/ microphoneattachment point. Using the antenna in theseways may damage the antenna and degrade yourtransceiver’s performance.INSTALLING THE ANTENNAChannel stopperArrowAntenna