Kenwood NEXEDGE NX-700 Instruction Manual

Also see for NEXEDGE NX-800 series: Brochure Function reference Instruction manual Instruction manual Specifications

12SCANScan monitors for signals on the transceiver channels. While scanning, thetransceiver checks for a signal on each channel and only stops if a signal ispresent.To begin scanning, press the key programmed as Scan.• The icon appears on the display.• When a signal is detected on a channel, Scan pauses at that channel. The transceiverwill remain on the busy channel until the signal is no longer present, at which time Scanresumes.To stop scanning, press the Scan key again.Note: To use Scan, there must be at least 2 channels in the scan sequence.TEMPORARY CHANNEL LOCKOUTDuring scan, you can temporarily remove specifi c channels from the scanningsequence by selecting them and pressing the key programmed as Scan Delete/Add.• The channel is no longer scanned. However, when scanning is ended and restarted, thechannels are reset and deleted channels will again be in the scanning sequence.PRIORITY SCANNote: To use Priority Scan, a Priority channel must be programmed.When using a single Priority channel, the transceiver will automatically change tothe Priority channel when a call is received on that channel, even if a call is beingreceived on a normal channel.When using dual Priority channels, Priority channel 1 is given precedence overPriority channel 2. So, if a call is received on Priority channel 1 while a call isalready on Priority channel 2, the transceiver will change to Priority channel 1.SCAN REVERTThe Scan Revert channel is the channel selected when you press the PTT switchto transmit during scan. Your dealer can program one of the following ScanRevert channels:• Selected: The last channel selected before scan.• Selected + Talkback: Same as “Selected”, plus you can respond to calls onthe channel at which scan is paused.• Priority 1/ Priority 2: The Priority channel (either Priority 1 or Priority 2).• Priority 1 + Talkback/ Priority2 + Talkback: Same as “Priority 1/ Priority 2”,plus you can respond to calls on the channel at which scan is paused.• Last Called + Selected: The last channel on which you receive a call.