Kenwood NEXEDGE NX-700 series Instruction Manual

Also see for NEXEDGE NX-800 series: Brochure Function reference Instruction manual Specifications Specifications

8■ Identification CodesAn ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.Each transceiver must have its own Fleet and ID number.• Enter a Fleet number (00 ~ 349) to make a group call.• Enter an ID number (000 ~ 4999) to make an individual call in your fleet.• Enter a Fleet number to make a call to all units in the selected fleet (Fleet call).• Enter an ID number to make a call to the selected ID in all fleets (Supervisor call).• Select “ALL” Fleet and “ALL” ID to make a call to all units (Broadcast call).Note: The ID range may be limited by programming.STATuS meSSAgeYou can send and receive 2-digit Status messages which may be decided in yourtalk group. Messages can contain up to 6 alphanumeric characters. Statusmessages range from 0 to 99 (80 ~ 99 are reserved for special messages).A maximum of 5 received messages can be stored in the stack memory of yourtransceiver. These saved messages can be reviewed after reception. Dependingon your dealer settings, when the stack memory is full, either the oldest messagewill be erased when a new message is received or the new message will not bestored in the stack memory. The icon lights when a message is stored in thestack memory.■ Transmitting1 Select your desired zone and channel.2 Press the key programmed as Status to enter Status mode or Selcall +Status to enter Selcall mode.• When using the Status key to enter Status mode, the target Fleet/ ID is fixed andcannot be selected. Skip to step 5 to continue.3 In Selcall mode, press the / keys to select the ID of the station you wantto call.• If Manual Dialing is enabled, you can enter the station ID by using themicrophone keypad, or by using the / keys. When using the / keys,cycle through the digits to select a digit, then press the key to setthe digit and move the cursor to the right. Repeat this process until theentire ID is entered.4 Press the key enter Status mode.5 Press the / keys to select the status ID you want to transmit.• If Manual Dialing is enabled, you can enter the station ID by using themicrophone keypad, or by using the / keys. When using the / keys,cycle through the digits to select a digit, then press the key to setthe digit and move the cursor to the right. Repeat this process until theentire ID is entered.6 Press the microphone PTT switch or the key to initiate the Status call.• “<>” is displayed when the call has been successfully transmitted.