Kenwood NX-300 Service Manual

Also see for NEXEDGE NX-300: Brochure Instruction manual Instruction manual Instruction manual Instruction manual

Contents

NX-3006■ Removing the TOP packing (G53-1762-02)1. Pull on the TOP packing with your fingers to turn it back asshown in the figure z.2. Pull the TOP packing to the left to remove the packing thatis fit into the left groove of the chassis x.3. Pull the TOP packing to the right to remove the packingthat is fit into the right groove of the chassis c.4. Remove the TOP packing v.2. Precautions for Disassembly■ Removing the TX-RX unit from the chassis1. Remove the cord ASSY from the connector of the TX-RXunit (CN900) z.2. Remove the PTT FPC from the connector of the TX-RXunit (CN901) x.3. Remove the 14 screws c.4. Anchor the screw hole of the TX-RX unit using the tip of apair of tweezers as shown in the figure. Then, lift the TX-RX unit to remove it from the chassis v.DISASSEMBLY FOR REPAIRCN901PTT FPC2TX-RX unitCN900Cord ASSY143 33 33 331 2341. Precautions for Waterproof• Do not remove the black sheet from the reverse side ofthe transceiver (refer to the illustration right). Removal ofthis sheet decreases the waterproof efficiency of thetransceiver and may cause malfunctions if water seepsinto the transceiver.• The orange packing material on the reverse side of thetransceiver is important with respect to the waterproofefficiency of the transceiver. Do not place stickers or othermaterials on or around the packing material shown in thefigure, or on the reverse side of the battery pack. Doing sowill impair the waterproof efficiency of the transceiver andmay cause it to break down. Additionally, in order toprevent damage to the packing material, do not allow it tocome in contact with foreign materials.