(No.RA032)1-494.9 Transmitter SectionItem Condition Measurement Adjustment Specifica-tions/RemarksPanel tuningmodePC test mode Test-equip-mentUnit Ter-minalUnit Parts Method1.RampupOffset1) Adj item:[RAMPU]Adjust:[****]2) Adj item:[700M RX/TALow]→[700M RX/TAHigh]→[700M TX Low]→[700M TXHigh]→[800M TX Low]→[800M TXHigh]→[800M RX/TALow]→[800M RX/TAHigh]PTT : ONPress [ ] key tostore the adjust-ment value.1) Adj item:[Ramp Up Offset]2) Adj item:[Frequency:700MHz Band][RX/TA Low]→[RX/TA High]→[TX Low]→[TX High][Frequency:800MHz Band][TX Low]→[TX High]→[RX/TA Low]→[RX/TA High]Press [Transmit]button.Press [Apply All]button to store theadjustment value.PowermeterAmmeterPanel ANT Panel [Paneltuningmode][],[][PCtestmode][←],[→][PC test mode][Automatic Adjust-ment]1) Press [Tune RumpOffset] button.2) Press [Apply All] but-ton to store the adjust-ment value after theautomatic adjustmenthas finished.3) Check Ramp UP Off-set Monitor Value Over45.[Manual Adjustment]1) Set the adjustmentvalue to “1”.2) Increase the adjust-ment value slowly whilemonitoring the offsetmonitor value.3) Set the adjustmentvalue when the offsetmonitor value exceed“50”.2.RampdownOffset1) Adj item:[RAMPD]Adjust:[****]2) Adj item:[700M RX/TALow]→[700M RX/TAHigh]→[700M TX Low]→[700M TXHigh]→[800M TX Low]→[800M TXHigh]→[800M RX/TALow]→[800M RX/TAHigh]PTT : ONPress [ ] key tostore the adjust-ment value.1) Adj item:[Ramp DownOffset ]2) Adj item:[Frequency:700MHz Band][RX/TA Low]→[RX/TA High]→[TX Low]→[TX High][Frequency:800MHz Band][TX Low]→[TX High]→[RX/TA Low]→[RX/TA High]Press [Transmit]button.Press [Apply All]button to store theadjustment value.PowermeterAmmeterPanel ANT Panel [Paneltuningmode][],[][PCtestmode][←],[→][PC test mode][Automatic Adjust-ment]1) If "Automatic Adjust-ment" is completed inthe item of "Ramp upOffset", this item is Com-pleted in addition.2) Check ''Ramp DownOffset'' monitor valueunder ''50'' with PTT ON[Manual Adjustment]1) Set the following val-ue with reference to thevalue that you applied inthe item of "Ramp upOffset"2)Write calcurated Val-ue "Ramp up Offset-70".3)If the subtraction re-sult is less than "1", ap-ply"1".
