Kenwood NX-800H Service Manual

Also see for NEXEDGE NX-800 series: Brochure Function reference Instruction manual Instruction manual Specifications

NX-800/800H93. Control Head Remote Kit (KRK-10: Option)The KRK-10 remote kit is used to remotely operate thetransceiver.3-1. Installing the KRK-10 kit to the transceiver1. Remove the front panel from the transceiver.2. Install the KRK-10 main panel onto the transceiver.3. Install the KRK-10 rear panel onto the front panel.4. Connect the KRK-10 main panel to the rear panel withthe cable.■ Remove the front panel from the transceiver1. Lift the two tabs of the panel on the bottom of the trans-ceiver with a flat-head screwdriver ( q ) and remove thepanel from the chassis ( w ).Note: Confirm that the tabs of the speaker hardware fix-ture and holder is securely fi tted in the front panel.2. Remove the flat cable from the connector (CN901) of thedisplay unit of the panel. ( e )3. Fold the black line of the flat cable (in three parts) asshown in Figure 3-2. ( r, t, y )CN901:@.Fig. 3-1B;=ChassissidePanelsideFig. 3-2■ Install the KRK-10 main panel onto the transceiver4. Insert the flat cable that was removed in step 2 aboveinto the connector (CN1) of the interface unit (A/2) of theKRK-10 main panel (A62-1101-11). ( u )Note: The terminal side of the flat cable must face downwhen inserting the fl at cable into the connector.5. Fit the main panel with four tabs onto the front of thechassis. ( i )Note: When installing the main panel onto the front ofthe chassis, hold down the flat cable with your fingers toprevent it from being caught.CN1KRK-10 main panel>2Fig. 3-3■ Install the KRK-10 rear panel onto the front panel6. Insert the flat cable attached to the interface unit (A/2) ofthe KRK-10 rear panel (A82-0056-21) into the connector(CN901) of the display unit of the panel ( o ). (The flatcable has been pre-inserted in the connector (CN2) ofthe rear panel at the time of shipping.)Note: The terminal side of the flat cable must face downwhen inserting the fl at cable into the connector.7. Fit the four tabs of the rear panel into the front panel. ( !0 )CN901CN2 KRK-10 rear panel8Fig. 3-4INSTALLATION;=B