Kenwood Nexedge NX-300GE Instruction Manual

Also see for Nexedge NX-200G: Instruction manual Instruction manual Service manual Instruction manual Instruction manual

11Select the desired channel/group ID using the Selector knob(default). Each channel/group ID is programmed with settingsfor transmitting and receiving.• You can toggle the display between the zone and channel/groupID names and number by pressing the key programmed as DisplayFormat, or by accessing the Menu {page 13}.Note: If the default settings for / and the Selector knobhave been changed, use the appropriate keys to select the zoneand channel/group ID.TRANSMITTING1 Select the desired zone and channel/group ID.2 Press the key programmed as [Monitor] or [Squelch Off]to check whether or not the channel is free.• If the channel is busy, wait until it becomes free.3 Press the PTT switch and speak into the microphone.Release the PTT switch to receive.• For best sound quality, hold the transceiver approximately1.5 inches (3 cm to 4 cm) from your mouth.■ Making Group Calls (Digital)If a key has been programmed with [Group] or [Group +Status], you can select a group ID from the list to make acall to those parties on a Conventional channel.To select a group ID:1 Press the key programmed as [Group] or [Group +Status].2 Press / to select a group ID/name from the list.3 Press and hold the PTT switch to make the call.• Speak into the transceiver as you would during a normaltransmission.