Kenwood RDX-VH7 Instruction Manual

Also see for RD-VH7: Service manual

Kenwood RDX-VH7 Instruction Manual Manual pdf 10 page image

RD-VH7/X-VH7 (EN)10System configuration, InstallationSystem configuration, InstallationSystem configurationThe VH series system components can be installed either vertically on the sides (lengthwise) or horizon-tally by stacking one component on another. If you purchased the RD-VH7 alone, install it properly by alsoreferring to the instruction manuals of the components to which it is connected.(Horizontally stacked installation)function indicatorDolby NRB-typerev.mode crls pauseC-type reverse forwarddirectionX-VH7(Layout)RD-VH7DM-VH7RD-VH7X-VH7DM-VH7(Vertical, lengthwise installation)CAUTION Caution for InstallationTo prevent fire hazard due to overheating, be sure to observe the information on this page when install-ing components horizontally by stacking them.÷ The RD-VH7 incorporates a ventilation fan and should always be stacked on the top of other components.÷ To avoid blocking heat radiation from the RD-VH7, do not place any object above it or behind the ventila-tion hole on the rear panel.Top : 50 cm Back panel : 10 cmfunction indicatorDolby NRB-typerev.mode crls pauseC-type reverse forwarddirectionNotesNotes÷ Before changing the installation layout, be sure to take out the CD, MD and cassette tape from thesystem components and unplug the power cords.÷ Be careful not to tilt down the system components by mistake. Otherwise the CD, MD and/or cas-sette tape left in them may be damaged.RD-VH7 + DM-VH7+ X-VH7(Amplifier-tuner/ CD player, MD recorder, Cassette deck )NoteNoteWith the horizontally stacked installation, be sure to usethe provided spacer. !Place each component so that itsLCD comes at the bottom as shownin the illustration.Be sure to change the feet beforevertical installation. !PREPARATION(Layout)