Kenwood TH-79E Instruction Manual

Also see for TH-79A: Instruction manual Instruction manual Instruction manual

From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document LibraryIfdifficulty is experienced in these cases, press [MR] while stillholding[PTT]downtoresend the code. AIWmatively, release[PTT] then press[PTT]again. Remember to switch ON the Pagefunction in advance.• When Page is ON, Scan cannot be used on the same band.+ When Page is ON, choosing theVFO,the Call channel, or amemory channel does not affect the Page status. Page remainsON.• When Page is switched ON while DTSS is ON, DTSSisswitchedOFF automatically.RECEIVINGThe squelch must be closed {page 16} on both bandsbefore beginning this procedure.1 Press [BAND] to select the Operating band andselect the prearranged frequency.2 Press [F], [PAG] to switch ON the Page function.• "PAG" appears.You are ready to receive a call addressed with yourStation code or a Group code. If nosig1nalis receivedfor more than 2 seconds after a Page has opened thesquelch, the squelch then closes.• Receiving a Call with your Station (:ode52When a signal is received encoded with yourindividual Station code, the squelch opens and youhear an alert tone from the speaker. In addition, theDisplay shows "PO" and the calling station's code.Press [PTT] while "PAG" is blinking to respond tothe calling party.•Receivingal~allwithaGroup CodeWhen a signal is received encoded with the correctGroup code, the squelch opens and you hear analert tone from the speaker. In addition, the Displayshows the received Group code and in whichmemory(1to 6) that Group code has been stored.Press [PTT] while "PAG" is blinking to respond tothe callingpa1rty.Note:• "Err" appears on the displayifyour dual bander fails to receivethe Page code correctly.• The microphone is inhibited while the Page code is transmitted.• It's advisable to tum OFF Battery Saver when you use Page.