TH-F6A/F7E3DISASSEMBLY FOR REPAIR3. Soldering the Bar antenna wiresBefore solding the bar antenna wires, form the wires asshown in the figure 2.Then solder the wires to lands on the PCB.Fig. 24. Removing a relay terminalInsert a screw driver between the relay terminal and itsholder.Then pull the relay terminal as shown in the figure 3.5. Assembling a release latchPlace a coil spring(1) on the release latch(2) as shown inthe figure 4.Then insert a shaft(3) into the release latch.Push the above assembly into the rear panel while theend of coil spring is hooked to the “A” tab.Fig. 4213Notch NotchA6. Caution at the time of reassemblingWhile you are reassembling the battery terminal holder(J19-5428) and the packing (G53-1532), confirm that thepacking is reassembled at the condition that any swell isnot occurred on it. If the packing is assembled with anyswell, width of body also becomes expansive.J19-5428G53-1532Swell notallowedFig. 3Fig. 5