Kenwood TK-2360 Service Manual

Also see for TK-2360: Instruction manual Instruction manual Instruction manual Instruction manual

Contents

TK-23603SYSTEM SET-UPREALIGNMENTChoose the type of transceiverTransceiver programmingDeliveryLicense and frequency allocated by FCCAre you using the speaker microphone?A personal computer, programming interface (KPG-22/22A),and FPU (programming software) are required for programming.(The frequency, TX power HI/LOW, and signaling data areprogrammed for the transceiver.)YESNOKMC-17, KMC-21 or KMC-45Speaker microphone(Option)Are you using the optional antenna? YESNOKRA-22 or KRA-26Optional antennaTX/RX 136~174 5.0W TK-2360 K,MFrequency range (MHz) RF power TypeMerchandise received1. ModesUser modeData programming modePC test mode PC tuning modePC modeFirmwareprograming modeMode FunctionUser mode For normal use.PC mode Used for communication between the trans-ceiver and PC.Data programmingmodeUsed to read and write frequency data andother features to and from the transceiver.PC test mode Used to check the transceiver using the PC.This feature is included in the FPU.Firmwareprograming modeUsed when changing the main program ofthe fl ash ROM. See page 5.2. How to Enter Each ModeMode OperationUser mode Power ONPC modeReceived commands from PCFirmwareprograming mode3. PC Mode3-1. PrefaceThe transceiver is programmed by using a personal com-puter, a programming interface (KPG-22/22A, USB adapter(KCT-53U)) and FPU (programming software).The programming software can be used with a PC orcompatible. Figure 1 shows the setup of a PC for program-ming.3-2. Connection Procedure1. Connect the transceiver to the personal computer withthe interface cable and USB adapter (when the interfacecable is KPG-22A, the KCT-53U can be used).