17SCANScan is useful for monitoring signals on the transceiverchannels. When scanning, the transceiver checks for a signalon each channel and only stops if a signal is present.The transceiver will remain on a busy channel until the signalis no longer present. Your dealer programs the delay timebetween signal drop-out and Scan resumption. If a signal isreceived during the delay time, the transceiver will remain onthe same channel.Note:◆ You can only use Scan if your dealer has programmed at least2 channels on the transceiver. Also, there must be at least 2channels not locked out of Scan.◆ Ask your dealer for an explanation on how Channel Scanfunctions when using 5-Tone or DTMF signalling.To start scanning, press the key programmed as Scan.• Scanning starts from the current channel and ascends throughthe channel numbers.• The LED flashes green.• When a signal is received on a channel and signalling matches,the LED indicator lights green.To end Scan, press the Scan key again.PRIORITY S CANIf your dealer set up a Priority channel on your transceiver, thetransceiver will automatically change to the Priority channelwhen a call is received on it, even if a call is being receivedon a regular channel.The transceiver will remain on the Priority channel until thesignal drops out. Your dealer programs the delay timebetween signal drop-out and Scan resumption.