Kenwood TK-3170 Service Manual

Also see for TK-3170: Function reference Instruction manual Instruction manual Specifications Instruction manual

TK-317016ADJUSTMENTTest Equipment Required for AlignmentTest Equipment Major Specifications1. Standard Signal Generator Frequency Range 400 to 520MHz(SSG) Modulation Frequency modulation and external modulationOutput –127dBm/0.1μV to greater than –47dBm/1mV2. Power Meter Input Impedance 50ΩOperation Frequency 400 to 520MHz or moreMeasurement Capability Vicinity of 10W3. Deviation Meter Frequency Range 400 to 520MHz4. Digital Volt Meter Measuring Range 10mV to 10V DC(DVM) Input Impedance High input impedance for minimum circuit loading5. Oscilloscope DC through 30MHz6. High Sensitivity Frequency Range 10Hz to 1000MHzFrequency Counter Frequency Stability 0.2ppm or less7. Ammeter 5A8. AF Volt Meter Frequency Range 50Hz to 10kHz(AF VTVM) Voltage Range 1mV to 10V9. Audio Generator (AG) Frequency Range 50Hz to 5kHz or moreOutput 0 to 1V10. Distortion Meter Capability 3% or less at 1kHzInput Level 50mV to 10Vrms11. 8Ω Dummy Load Approx. 8Ω, 3W12. Regulated Power Supply 5V to 10V, approx. 5AUseful if ammeter equipped■ Antenna Connector AdapterThe antenna connector of this radio uses an SMA termi-nal. Use an antenna connector adapter [SMA(f) – BNC(f) orSMA(f) – N(f)] for adjustment. (The adapter is not provided asan option, so buy a commercially-available one.)■ Battery Jig (W05-0909-00)Connect the power cable properly between the battery jiginstalled in the transceiver and the power supply, and be sureoutput voltage and the power supply polarity prior to switch-ing the power supply ON, otherwise over voltage and reverseconnection may damage the transceiver, or the power supplyor both.When using the battery jig in user mode, the transceiverassumes that a lithium-ion battery pack is attached to thetransceiver. In adjustment mode, battery type detection isnot performed. Refer to page 22 for details.Note : When using the battery jig, you must measure thevoltage at the terminals of the battery jig. Otherwise, a slightvoltage drop may occur within the power cable, between thepower supply and the battery jig, especially while the trans-ceiver transmits.+ Terminal (Red)– Terminal (Black)■ Nut wrenchIn order to turn the volume nut and the channel selectornut, use a recommendation tool.KENWOOD part No. : W05-1123-00S–+C1100P/25VC2470P/25VC3100/25VR11.8M++Terminal(Red)–Terminal(Black)PowersupplyPowercableSchematic diagram