Kenwood TK-3310 Service Manual

Contents

TK-33103SYSTEM SET-UPREALIGNMENTChoose the type of transceiverTransceiver programmingDeliveryMerchandise receivedAre you using the speaker microphone?A personal computer, programming interface (KPG-22A/22U),and FPU (programming software) are required for programming.(The frequency, TX power HI/LOW, and signaling data areprogrammed for the transceiver.)YESNOKMC-21, KMC-45 or KMC-48GPSSpeaker microphone(Option)Are you using the optional antenna? YESNOKRA-23 or KRA-27Optional antennaRX 450~5205.0WTK-3310 X(LMR)Frequency range (MHz) RF power TypeTX/RX 476.4250~477.41255.0WTK-3310 X(CB)TX 450~500(Option)1. ModesUser modeData programming modePC test mode PC tuning modePC modeWireless clone modeFirmware version information modeSelf-programming modeMode FunctionUser mode For normal use.PC mode Used for communication between the trans-ceiver and PC.Mode FunctionData programmingmodeUsed to read and write frequency data andother features to and from the transceiver.PC test mode Used to check the transceiver using the PC.This feature is included in the FPU.Wireless clonemodeUsed to transfer programming data from onetransceiver to another.Firmware versioninformation mode Used to confi rm the internal fi rmware version.Self-programmingmodeYou can program the frequency, signaling andother functions using only the transceiver.2. How to Enter Each ModeMode OperationUser mode Power ONPC mode Received commands from PCWireless clone mode [Firmware versioninformation mode[Side1] + [Side2] + Power ON (Twoseconds)Self-programming mode [S] + Power ON (Two seconds)