Kenwood TK-3310 Service Manual

Contents

TK-33106REALIGNMENT5. Self Programming ModeWrite mode for frequency data and signaling, etc. To beused ONLY by the authorized service person maintaining theuser's equipment. After programming, reset the FPU to the“Self- Programming” disabled mode. Transceivers CANNOTbe delivered to the end-user in the self-programming mode.5-1. Enter to the Self Programming ModePress and hold the [S] key for 2 seconds while turningthe transceiver power ON.When the transceiver enters in the self programmingmode, “1- 1” is displayed 2 seconds after “SELF” is dis-played.Note:This mode (self programming mode) cannot be set whenit has been disabled with the FPU.5-2. Adding the Data PasswordIf the Data password is set to the transceiver, you mustenter the password to activate a self programming mode.The maximum length of the password is 6 digits.The following describes how to enter the password.1. Press and hold the [S] key for 2 seconds while turningthe transceiver power ON.2. “SLF.LOCK.R” (When the Read authorization password isset to the transceiver.) / “SLF.LOCK.W” (When the Over-write password is set to the transceiver.) is displayed onthe LCD.3. If the [selector] knob is rotated while “SLF.LOCK.R”/ “SLF.LOCK.W” is displayed, the number (0 to 9) fl ashes on theLCD.When you press the [C>] key, the currently selected num-ber is determined.If you press the [A] key, the least digit of the password isdeleted.If you press the [S] key after entering the password in thisprocedure, “SELF” is displayed if the entered password iscorrect.If the password is incorrect, “SLF.LOCK.R”/ “SLF.LOCK.W”is redisplayed.5-3. Channel Selection ModeIn this mode, the Zone or Channel can be selected.Press and hold the [S] key for 2 seconds while turningthe transceiver power ON to enter self programming mode.When the transceiver enters in the self programming mode,the transceiver automatically enters the Channel Selectionmode.2 seconds after displaying “SELF", “1- 1” appears on theLCD.The setup item for channel selection mode is as follows.Setup item Display RemarksSelectZone/Channel*** - ****** - ***Zone: 1~128Channel: 1~128Key operationKey Key Function[Selector] Toggle between Zone selection and Channel selec-tion[Side1] No action[Side2] No action[S] Enter the Item Setting mode[A] Return to the Channel Selection mode[ Decrement the blinking Zone/Channel number by 1.Press and hold to decrement in steps of 10.[C>] Increment the blinking Zone/Channel number by 1.Press and hold to decrement in steps of 10.Note:If a non-existing Zone-Channel is selected and the mem-ory for all 128 channels is already filled, an error tone willsound and “MEM.FULL” will appear on the LCD for 2 sec-onds.5-4. Item Selection ModeIn this mode, the following items can be selected.• RX frequency• RX signaling• TX frequency• TX signaling• RF power Hi/Low (LMR model only)• Scan Del/Add (LMR model only)• Beat shift on/off (LMR model only)• Compander on/off (LMR model only)When the [S] key is pressed in the Channel Selectionmode, the transceiver enters the Item Selection mode.Key operationKey Key Function[Selector] The selected item changes[Side1] No action[Side2] No action[S] Enter the Item Setting mode[A] Return to the Channel Selection mode[ Error tone sounds[C>] Error tone sounds