Kenwood TK-360G Service Manual

Also see for TK-360G: Instruction manual Instruction manual Service manual

Contents

TK-360G/370G2GENERAL / SYSTEM SET-UPINTRODUCTIONSCOPE OF THIS MANUALThis manual is intended for use by experienced techniciansf a m i l i a r w i t h s i m i l a r t y p e s o f c o m m e r c i a l g r a d ecommunications equipment. It contains all required serviceinformation for the equipment and is current as of thepublication date. Changes which may occur after publicationare covered by either Service Bulletins or Manual Revisions.These are issued as required.ORDERING REPLACEMENT PARTSWhen ordering replacement parts or equipmentinformation, the full part identification number should beincluded. This applies to all parts, components, kits, or chassis.If the part number is not known, include the chassis or kitnumber of which it is a part, and a sufficient description of therequired component for proper identification.PERSONNEL SAFETYThe following precautions are recommended for personnelsafety:l DO NOT transmit until all RF connectors are verified secureand any open connectors are properly terminated.l SHUT OFF and DO NOT operate this equipment nearelectrical blasting caps or in an explosive atmosphere.l This equipment should be serviced by a qualified technician only.SERVICEThis radio is designed for easy servicing. Refer to theschematic diagrams, printed circuit board views, and alignmentprocedures contained within.NOTEWE CANNOT guarantee oscillator stability when usingchannel element manufactured by other than KENWOOD orits authorized agents.Unit X57-5880-XX X54-3250-XXModel & Frequency range Remarks Whip Antenna Charger Battery 16 Keydestination 0-10 0-11 0-21 0-10TK-360G K _ – OP –M _ – 450~470MHz IF1 : 49.95MHz _ OP OP –TK-370G K _ _ LOC : 50.4MHz OP _M _ _ _ _SYSTEM SET-UPMerchandise receivedLicense and frequency allocated by FCCChoose the type of transceiverTransceiver programmingDeliveryAre you using the speaker microphone?TX/RX 450~470 4.0W TK-360G K,M TK-370G K,MFrequency range (MHz) RF power TypeA personal computer (IBM PC or compatible), programminginterface (KPG-22), and programming software (KPG-56D)are required for programming.(The frequency, TX power HI/LOW, and signalling data are programmedfor the transceiver.)YESNOKMC-17 or KMC-21Speaker microphone(Option)