TK-360G/370G33ADJUSTMENTTest Equipment Required for AlignmentTest Equipment Major Specifications1. Standard Signal Generator Frequency Range 450 to 470MHz(SSG) Modulation Frequency modulation and external modulation.Output -127dBm/0.1μV to greater than -47dBm/1mV2. Power Meter Input Impedance 50Ω.Operation Frequency 450 to 470MHz or more.Measurement Range Vicinity of 10W3. Deviation Meter Frequency Range 450 to 470MHz.4. Digital Volt Meter Measuring Range 10mV to 10V DC(DVM) Input Impedance High input impedance for minimum circuit loading.5. Oscilloscope DC through 30MHz.6. High Sensitivity Frequency Range 10Hz to 1000MHz.Frequency Counter Frequency Stability 0.2ppm or less.7. Ammeter 5A.8. AF Volt Meter Frequency Range 50Hz to 10kHz.(AF VTVM) Voltage Range 1mV to 10V.9. Audio Generator (AG) Frequency Range 50Hz to 5kHz or more.Output 0 to 1V.10. Distortion Meter Capability 3% or less at 1kHz.Input Level 50mV to 10Vrms.11. Spectrum Analyzer Measuring Range DC to 1GHz or more12. Tracking Generator Center frequency 50kHz to 600MHzOutput Voltage 100mV or more13. 8Ω Dummy Load Approx. 8Ω, 3W.14. Regulated Power Supply 5V to 10V, approx. 3AUseful if ammeter equipped.n The following parts are required for adjustment1. Antenna connector adapterThe antenna connector of this radio uses an SMA terminal.Use an antenna connector adapter [SMA(f) – BNC(f) orSMA(f) – N(f)] for adjustment. (The adapter is not provided asan option, so buy a commercially-available one.)NoteWhen the antenna connector adapter touches the knob,draw out the knob to mount the connector.Repair Jig (Chassis)1. Jig (chassis : Part No. A10-4009-03) for adjustment.2. Use the jig as follows.1 Place the TX-RX unit on the jig and fix it with thirteenscrews z .2 Solder the antenna terminal of the TX-RX unit.3. Supply power from an external power supply.Relay terminal : + (7.5)Jig (Chassis) : -Relay terminal(+)Power moduleUNITJIGCoaxial antenna connectorz zzzzzzzz z