Kenwood TK-5810H Service Manual

Also see for FleetSync TK-5810(H): Instruction manual Specifications Service manual Instruction manual

Contents

5TK-5810H(B)DISASSEMBLY FOR REPAIRDisassembly Procedure (TK-5810H (B))■ Removing the upper/ lower case and shield cover1. Remove the 12 screws z and 12 spacers x.2. Remove the upper case c and lower case v.3. Remove the upper packing b and lower packing n.4. Remove the shielding plate m-1.5. Remove the shielding plate m-2.■ Removing the TX-RX unit (X57-727)1. Remove the 7 screws , holding the PLL shield cover.2. Remove the PLL shield cover ..3. Remove the coaxial cables from the two connectors(CN150, CN200) of the TX-RX unit /.4. Remove the flat cables from the two connectors (CN600,CN601) of the TX-RX unit Ω.5. Remove the 5 screws ≈.Final unitControlunitTX-RXunit36588 8 8 87 -1 7 -2911111415 1516 1612121242212 21 1211CN150CN200CN601CN600101013CN70217 1717 1717 171717171717■ Removing the Final unit (X45-380)1. Remove the cables from the connector (CN702) of thecontrol unit ç.2. Remove the 2 screws √ holding the power module.3. Remove the solder of the power module with a solderabsorber.4. Remove the 4 screws ∫ holding the two final transistors.5. Remove the 2 screws ~ holding the + (positive) terminaland - (negative) terminal of the power supply cable.6. Remove the 16 screws μ holding the final unit.7. Remove the solder of the antenna receptacle with asolder absorber.Note :When re-installing the flat cable to the connector on theCN600 side, do not align the cable as shown in the figure1, as there is a possibility of producing an effect on thesensitivity of P25.WrongRightFig. 1CN600Fig. 2