4■ Installing the TransceiverWARNING!FOR PASSENGER SAFETY, INSTALL THE TRANSCEIVER SECURELY, USING THESUPPLIED MOUNTING BRACKET, SO THE TRANSCEIVER WILL NOT BREAK LOOSE IN THEEVENT OF A COLLISION.1 Mark the position of the holes in the dash by using the mounting bracketas a template. Drill the holes, then attach the mounting bracket using thesupplied 5 x 16 mm screws.ï Be sure to mount the transceiver in a location where the controls will be withineasy reach of the user, and where there is sufficient space at the rear of thetransceiver for cable connections.2 Connect the antenna and the supplied power cable to the transceiver.3 Slide the transceiver into the mounting bracket and secure it using thesupplied hex-headed screws.4 Mount the microphone hanger, using the supplied 4 x 16 mm screws, in alocation where it will be within easy reach of the user.ï The microphone and microphone cable should be mounted in a place wherethey will not interfere with the safe operation of the vehicle.5 Connect one plug of the microphone cable to the jack on the base of themicrophone, and the other plug to the microphone jack on the front panelof the transceiver. Place the microphone on the hanger.MicrophonehangerMicrophoneMicrophone cableMounting bracketAntennaconnectorTransceiverPower inputconnectorPower cable BatteryFuse holderFuseHex headedscrewRed wireBlack wire