Kenwood TK-7102H Instruction Manual

Also see for TK-7102H: Specification Service manual Service manual Service manual

Contents

7SCANTo activate the Scan function, press the key programmed as Scan On/ Off.ï The indicator next to the programmed key flashes (ì î or ì î).When a signal is detected on a channel, the Scan indicator stops flashing. Atthis time, both the Scan indicator and the Busy indicator light.When the signal is no longer present, Scan resumes and the Scan indicatorflashes again.To stop scanning, press the Scan On/ Off key again.ï The transceiver returns to the channel that was selected before Scan started.TEMPORARY D ELETEDepending on how your transceiver has been set up, a key may have beenprogrammed with the Temporary Delete function. If so, press and hold thatprogrammed key for approximately 1 second to temporarily remove undesiredchannels from the scanning sequence. This allows you to scan only thosechannels which you desire. After switching the Scan function OFF, or switchingthe transceiver OFF and then ON again, the Scan settings return to normal.Note: In order for Scan to function, there must be at least 2 channels added to the scanningsequence. If there are less channels than this, Scan does not operate.R EVERT CHANNELDuring Scan, pressing the PTT switch to transmit will cause the transceiver toselect the revert channel. Your dealer programs the Revert channel for yourtransceiver. Consult your dealer for details.