Kenwood TK-7102H Service Manual

Also see for TK-7102H: Specification Instruction manual Service manual Service manual

TK-7102H35. INSTALLATION PLANNING – CONTROL STATIONS5-1. Antenna systemControl station. The antenna system selection depends onmany factors and is beyond the scope of this manual. YourKENWOOD dealer can help you select an antenna systemthat will best serve your particular needs.5-2. Radio locationSelect a convenient location for your control station radiowhich is as close as practical to the antenna cable entry point.Secondly, use your system’s power supply (which suppliesthe voltage and current required for your system). Make suresufficient air can flow around the radio and power supply toallow adequate cooling.SERVICEThis radio is designed for easy servicing. Refer to theschematic diagrams, printed circuit board views, and align-ment procedures contained in this manual.Speakerjack capPower inputconnectorAntennaconnectorNOTEIf you do not intend to use the 3.5-mm jack for the externalspeaker, fit the supplied speaker-jack cap to stop dust andsand from getting in.Merchandise receivedLicense and frequency allocated by FCCChoose the type of transceiverTransceiver programmingKCT-39Connection cableKCT-18Ignition sense cableKCT-36Extension cableKDS-100Mobile dataterminalKGP-2AModem GPS receiver orKGP-2BModem GPS controllerKES-3External speakerSee page 8.A personal computer (IBM PC or compatible), programming interface (KPG-46),and programming software (KPG-70D) are required for programming.Frequency range (MHz) RF power Type146~174 50W K,M136~162 50W K2,M2(Option)(Option)(Option)(Option)(Option)(Option)orDeliveryGENERAL / SYSTEM SET-UPSYSTEM SET-UP