TK-7160/716274-1. Adding the data password.If the Read Authorization password is set in the optionalfeature menu, you must enter the password (Master trans-ceiver) to activate a clone mode.You can use 0~9 to configure the password. The maxi-mum length of the password is 6 digits.1. [ ]+Power ON.2. “CLN LOCK” (TK-7160) or “P” (TK-7162) is displayed onthe LCD.3. If the [ ] and [ ] keys is pressed while “CLN LOCK”(TK-7160) or “P” (TK-7162) is displayed, numbers (0 to 9)are displayed flashing. When you press the [ ] key, thecurrently selected number is determined. If you press the[ ] key after entering the password in this procedure,“CLONE” (TK-7160) or “C” (TK-7162) is displayed if theentered password is correct. If the password is incorrect,“CLN LOCK” (TK-7160) or “P” (TK-7162) is redisplayed.Clone cable(E30-3382-05)Fig, 2■ Flow Chart (Master radio)Press [ ] key+Power ON for 2 secondsIspassword*set?YesNo Shows CLN LOCK or CInput password ifpassword is correctClone mode[ ]Start the clone function* ReadAuthorizationpassword5. Self Programming ModeSelf programming mode operates with only the TK-7160transceiver.Write mode for frequency data and signaling, etc. To beused ONLY by the authorized service person maintaining theuser’s equipment. After programming, reset the FPU to the“Self- Programming” disabled mode. Radios CANNOT bedelivered to the end-user in the self-programming mode.5-1. Enter to the Self Programming ModeHold down the [ ] key 2 seconds and turn the powerswitch on. When enter the self programming mode, “1- 1”is displayed 2 seconds after “ SELF ” is displayed.5-2. Adding the Data PasswordIf the data password is set in the optional feature menu,you must enter the password to activate a self programmingmode.You can use 0~9 to configure the password. The maxi-mum length of the password is 6 digits.1. [ ]+Power ON.2. “SLF.LOCK.R”* is displayed on the LCD.3. If the [ ] and [ ] keys is pressed while “SLF.LOCK.R”is displayed, numbers (0 to 9) are displayed flashing.When you press the [ ] key, the currently selectednumber is determined. If you press the [ ] key after en-tering the password in this procedure, “SELF” is dis-played if the entered password is correct. If the passwordis incorrect, “SLF.LOCK.R”* is redisplayed.* Read authorization password → “SLF.LOCK.R”Overwrite password → “SLF.LOCK.W”Note :This mode (self programming mode) cannot be set whenit has been disabled with the FPU.5-3. Channel Setting ModeEach channel can be setup in its action mode by using thepanel keys.The 5-tone functions cannot be programmed in this mode.• Pressing [ ] when “1- 1” is displayed, sets channelsetting mode.• Select an item set using [ ] then change the selectionwith the [ ] or [ ].• The data displayed using [ ] is stored in the memory.• Pressing [ ] proceeds to the next item without storing itin the memory.• Press [ ] to set the display to “ SELF ” and return toreset (default) status.REALIGNMENT