Kenwood TK-7160 Service Manual

Also see for TK-7160: Instruction manual Service manual Specifications Brochure & specs Instruction manual

TK-716097. Ignition Sense Cable (KCT-18)The KCT-18 is an optional cable for enabling the ignitionfunction. The ignition function lets you turn the power to thetransceiver on and off with the car ignition key.7-2. Connecting the KCT-18 to the Transceiver1. Install the KCT-39 in the transceiver. (See the KCT-39 sec-tion)2. Insert the KCT-18 lead terminal ( 1 ) into pin 2 of the KCT-39 ( 2 ).211315137-3. Modifying the TransceiverModify the transceiver as follows to turn the power on andoff with the ignition key.1. Remove the jumper resistor (0Ω) R95 of the TX-RX unit.■ Setting With the KPG-99DSelect “Function port” from the “Edit” menu and enablethe “Ignition Sense”.Fig. 7Fig. 8R95CN2TX-RX UNITComponent sideREALIGNMENT / INSTALLATION1. PA/HA Unit (KAP-2 : Option)1-1. Installing the KAP-2 in the TransceiverThe Horn Alert and Public Address functions are enabledby inserting the KAP-2 relay unit.■ Installation ProcedureThe accessories of KAP-2 use “KIT A” for this transceiver.1. Open the case and shield cover of the transceiver.2. Remove the jumper lead from CN6 connector on the TX-RX unit.3. Lift the DC cord bushing ( 1 ) from the chassis and re-move the pad as shown in the Figure 1 ( 2 ).12Fig. 14. Affix the new pads (supplied with the KAP-2) to the DCcord ( 3 ) and chassis ( 4 ).34G13-2083-04(9 x 3.5 x 4 mm)G13-2084-04(6 x 6 x 1.5 mm)Fig. 2