Kenwood TK-7185E Instruction Manual

Also see for TK-7185: Instruction manual Service manual addendum

2Various electronic equipment in your vehicle may malfunction if they are not properly protected fromthe radio frequency energy which is present while transmitting. Electronic fuel injection, anti-skidbraking, and cruise control systems are typical examples of equipment that may malfunction. Ifyour vehicle contains such equipment, consult the dealer for the make of vehicle and enlist his/heraid in determining if they will perform normally while transmitting.Note: The following preparation instructions are for use by your KENWOOD dealer, an authorizedKENWOOD service facility, or the factory.TOOLS REQUIREDNote: Before installing the transceiver, always check how far the mounting screws will extend belowthe mounting surface. When drilling mounting holes, be careful not to damage vehicle wiring orparts.The following tools are required for installing the transceiver:• 1/4 inch (6 mm) or larger electric drill• 5/32 inch (4.2 mm) drill bit for the self-tapping screws• Circle cuttersPOWER CABLE CONNECTION◆ The transceiver operates in 12 V negative ground systems only! Check the battery polarity andvoltage of the vehicle before installing the transceiver.◆ Do not cut and/or remove the fuse holder on the DC power cable.1 Check for an existing hole, conveniently located in the firewall, where the powercable can be passed through. If no hole exists, use a circle cutter to drill thefi rewall, then install a rubber grommet.2 Run the two power cable leads through the fi rewall and into the enginecompartment, from the passenger compartment.3 Connect the red lead to the positive (+) battery terminal and the black lead tothe negative (–) battery terminal.• Locate the fuse as close to the battery as possible.4 Coil and secure the surplus cable with a retaining band.• Be sure to leave enough slack in the cables so the transceiver can be removed forservicing while keeping the power applied.PREPARATION