Kenwood TK-760G series Instruction Manual

Also see for TK-760G series: Service manual Service manual Instruction manual Service manual

16TRANSMITTINGNote: You can also transmit using a TK-762G/ TK-862G transceiver.1 Press and hold the PTT switch.2 Enter the code of the transceiver you want to call or enter a Group code onthe keypad.• Be sure to enter the ID or Group code, followed by the Intermediate code of thetransceiver you want to call. If desired, you can also enter a message code of up to 5digits.• If desired, you can send codes the same way you make DTMF calls {page 12}. Bothmanual methods can be used or you can store codes in memory, then dial them from amemory location.• TK-760G/ TK-860G only: “CALL” appears on the display and the LED indicator lightsred.3 Use the transceiver the same as in a regular call; press the PTT switch totransmit and release it to receive.• When you release the PTT switch, squelch turns OFF and the LED indicator flashesorange (depending on dealer programming). When you receive a signal, the LEDindicator alternates between green and orange. When the signal drops out, the LEDindicator flashes orange again. If no signal is received for a pre-determined time,squelch turns back ON.• Pressing the key programmed as Monitor at any time will turn the squelch back ON.