Kenwood TK-785 Instruction Manual

Also see for TK-785: Service manual

Contents

8Voice Callsn Making a Voice Call1 Select a call address using one of the following four methods:i)Select a call address from memory: Select your desired call addressusing the / (control) keys if a call address has been stored inthe transceiver memory.ii)Use a pre-programmed key: Press key A, B, C, or D to select acall address if they have been pre-programmed with call addresses.iii)Select a call address from the stack: Use a received voice call from thestack as a call address (refer to “Viewing the Stack”, on page 10).iv)Enter a call address using the microphone keypad: Enter your desiredcall address using the microphone keypad (keys 0 ~ 9, , and #).Refer to the appendix {page 15} for the available dial strings andcontrol codes.2 Initiate the call, depending on how you selected the call address.i, ii, and iii (of step 1):When selecting a call address from memory or the stack, press the CALLkey (or the microphone PTT switch if “PTT to Initiate Call” has beenprogrammed) to initiate the call.iv (of step 1):When using MPT1343 dialing, press the microphone # key to initiate thecall.• “Calling” appears on the display.3 When the call is connected, a timer appears on the display.• The timer can be set up to either count up (increasing number) or count down(decreasing number).4 Press the microphone PTT switch to transmit; release it to receive.• The LED lights red while transmitting.• The 3-digit sub-display shows your transmit power. A single triangle (s)represents low power while dual triangles (ss) represents high power.5 Press the key to end the call. If the call time expires before you pressthe key, the call will be automatically terminated.• “END” momentarily appears on the display before returning to the call addressof the call you just made.