Kenwood TK-785 Instruction Manual

Also see for TK-785: Service manual

Contents

10n Receiving a Status/Short Data Message Call1 When a call is received, the indicator appears on the display andflashes.• The indicator remains on the display when there is data in the stack.2 To view the status or message, refer to “Viewing the Stack”, below.Call DisplaysThe following messages may appear on the display under certain circumstances:Holding: The transceiver is confirming the call made by the base station.Engaged: The called party is in another call.Queued: All communication channels are currently in use; your status will besent when a channel becomes free.Fail: The control station received an invallid call.NU: You entered an invallid call address.No Reply: The called party has been called, but they did not respond to the call.Call Back: The called party has set their transceiver to queue all incoming calls.Sys Busy: The system is currently busy.Viewing the Stack1 Press the Status/ Stack key (default is the A key) twice to enter the stack.• If there is no data in the stack, “------------” appears on the main display and “-00”appears on the 3-digit sub-display.2 Press the / (control) keys to view the stack entries.• “NEW” represents a new entry, “S” represents a status stack entry, “V” represents avoice stack entry, and “D” represents a data stack entry.3 Press the C and D keys to scroll through the selected entry, to view theentire entry.4 To erase an entry, select the desired entry and press the key.