Kenwood TK-8180 Service Manual

Also see for TK-8180: Modification Information Function reference Brochure & specs Specification Instruction manual

TK-818038Test Equipment Required for AlignmentTest Equipment Major Specifications1. Standard Signal Generator Frequency Range 400 to 520MHz(SSG) Modulation Frequency modulation and external modulationOutput 0.1μV to greater than 1mV2. Power Meter Input Impedance 50ΩOperation Frequency 400 to 520MHz or moreMeasurement Capability Vicinity of 50W3. Deviation Meter Frequency Range 400 to 520MHz4. Digital Volt Meter Measuring Range 1 to 20V DC(DVM) Accuracy High input impedance for minimum circuit loading5. Oscilloscope DC through 30MHz6. High Sensitivity Frequency Range 10Hz to 600MHzFrequency Counter Frequency Stability 0.2ppm or less7. Ammeter 13A or more8. AF Volt Meter Frequency Range 50Hz to 10kHz(AF VTVM) Voltage Range 3mV to 3V9. Audio Generator (AG) Frequency Range 50Hz to 5kHzOutput 0 to 1V10. Distortion Meter Capability 3% or less at 1kHzInput Level 50mV to 10Vrms11. Voltmeter Measuring Range 10 to 1.5V DC or lessInput Impedance 50kΩ/V or greater12. 4Ω Dummy Load Approx. 4Ω, 20W13. Regulated Power Supply 13.6V, approx. 20A (adjustable from 9 to 20V)Useful if ammeter requipped181 : BLC2 : +B3 : GND4 : PTT/TXD(PC serial datafrom radio)MIC connector (Front panel view)5 : MICE6 : MIC7 : HOOK/RXD(PC serial datato radio)8 : DMTest cable for microphone input (E30-3360-08)3245678312456781 GREENREDBLACKBLUESHIELDWHITEGRAYYELLOWPTTEMIC-EMICHKTuning cable (E30-3383-05)Adapter cable (E30-3383-05) isrequired for injecting an audio ifPC tuning is used.See “PC Mode” section fot theconnection.Lead wire +MICShield wire –ADJUSTMENTto transceiverto VGS-1Check Jig for the VGS-1KENWOOD part : W05-1127-00