Kenwood TK-860G Service Manual Supplement

Also see for TK-860G series: Instruction manual Instruction manual Service manual Service manual Service manual

Contents

3TK-860G/862GOPERATING FEATURESFoot switch 1 push (Hold it down for about one second.)Emergency modeEmergency channel LCD dot status changeTX 25 sec. ←→ RX 5 sec.Emergency ACK code receiveFoot switch 1 pushHorn/Light operation stopHorn/Light operation[D/A] key 1 pushEmergency reset code receive [MON] key + Foot SW 1 pushEmergency mode resetNormal operationAfter 1 min.*2*2*1LCD dot status change*1DotDotoror Emergency mode system chart (TK-862G)*1 : When the dot indicator is on, it turns off.When the dot indicator is off, it turns on.*2 : Hold the foot switch again for about one second.Radio Password (TK-860G only)When the password is set in the transceiver, user can notuse the transceiver unless enter the correct password.This code can be up to 6 digits from 0 to 9 and input withthe key, and "SCN" key.EmergencyPressing this key for longer than 1 second causes thetransceiver to enter the emergency mode. The transceiverjumps to the programmed "Emergency the group and chan-nel" and transmits for 25 seconds.The transceiver disables mic mute while transmitting.After finishing transmission, the transceiver receivers for 5seconds. The transceiver mutes the speaker while receiv-ing. Following the above sequence, the transceiver contin-ues to transmit and receive. Emergency mode system chart (TK-860G)Foot switch 1 push (Hold it down for about one second.)Emergency modeEmergency channel LCD dots lightTX 25 sec. ←→ RX 5 sec.Emergency ACK code receiveFoot switch 1 pushHorn/Light operation stopHorn/Light operation[D/A] key 1 pushEmergency reset code receive [MON] key + Foot SW 1 pushEmergency mode resetNormal operationAfter 1 min.*2*2*1DotsDotsLCD dots light*3oror*1 : 3 left most dots light.*2 : Hold the foot switch again for about one second.*3 : 2 right most dots light.