Kenwood TK-860G Service Manual Supplement

Also see for TK-860G series: Instruction manual Instruction manual Service manual Service manual Service manual

Contents

4TK-860G/862G REALIGNMENTClone ModeProgramming data can be transferred from one radio toanother by connecting them via their modular microphonejacks. The operation is as follows (the transmit radio is themaster and the receive radio is the slave).1. Turn the master TK-860G power ON with the [ ] keyheld down. If the password is set to the TK-860G, theTK-860G displays "CLN LOCK". If the password is notset, the TK-860G displays "CLONE".2. When "CLN LOCK" is displayed, only the [CH / ] keyand [SCN], and [0] to [9] keys can be accepted. Whenyou enter the correct password, and "CLONE" is dis-played, the TK-860G can be used as the cloning master.The following describes how to enter the password.3. How to enter the password with the microphone keypad;If you press a key while "CLN LOCK" is displayed, thenumber that was pressed is displayed on the TK-860G.Each press of the key shifts the display in order to theleft. When you enter the password and press the [SCN]key, "CLONE" is displayed if the entered password is cor-rect. If the password is incorrect, "CLN LOCK" isredisplayed.How to enter the password with the [CH / ] key;If the [CH / ] key is pressed while "CLN LOCK" is dis-played, numbers (0 to 9) are displayed flashing. Whenyou press the [SCN] key, the currectly selected number isdetermined, and the display shifts to the left. If you pressthe [SCN] key after entering the password in this proce-dure, "CLONE" is displayed if the entered password iscorrect. If the password is incorrect, "CLN LOCK" isredisplayed.4. Power on the slave TK-860G/862G.5. Connect the cloning cable (No. E30-3382-05) to themodular microphone jacks on the master and slave.6. Press the [SCN] key on the master while the master dis-plays "CLONE". The data of the master is sent to theslave. While the slave is receiving the data, "–PC–" is dis-played. When cloning of data is completed, the masterdisplays "END", and the slave automatically operates inthe User mode. The slave can then be operated by thesame program as the master.7. The other slave can be continuously cloned. When the[SCN] key on the master is pressed while the master dis-plays "END", the master displays "CLONE". Carry out theoperation in step 4 to 6.Note :You can clone the programmed data between the trans-ceiver frequency version must be same.Cloning cable(E30-3382-05)Fig. 1MBLPSBGNDPTT/TXDMEMICHOOK/RXDCMGNDREMOTE/TXDPTT/RXD8118Clone cableE30-3411-05 (TK-860G → TK-360G/370G)