Kenwood TK-863G Service Manual

Also see for TK-863G: Brochure & specs Brochure & specs Instruction manual Brochure & specs

2TK-863G GENERAL / SYSTEM SET-UPINTRODUCTIONSCOPE OF THIS MANUALThis manual is intended for use by experienced techni-cians familiar with similar types of commercial grade com-munications equipment. It contains all required service in-formation for the equipment and is current as of the publica-tion date. Changes which may occur after publication arecovered by either Service Bulletins or Manual Revisions.These are issued as required.ORDERING REPLACEMENT PARTSWhen ordering replacement parts or equipment informa-tion, the full part identification number should be included.This applies to all parts : components, kits, or chassis. If thepart number is not known, include the chassis or kit numberof which it is a part, and a sufficient description of the re-quired component for proper identification.PERSONNEL SAFETYThe following precautions are recommended for person-nel safety :• DO NOT transmit if someone is within two feet (0.6meter) of the antenna.• DO NOT transmit until all RF connectors are verified se-cure and any open connectors are properly terminated.• SHUT OFF and DO NOT operate this equipment nearelectrical blasting caps or in an explosive atmosphere.• All equipment should be properly grounded beforepower-up for safe operation.• This equipment should be serviced by a qualified techni-cian only.SERVICEThis radio is designed for easy servicing. Refer to theschematic diagrams, printed circuit board views, and align-ment procedures contained in this manual.NoteWhen you modify your radio as described in system set-up, take the following precaution.The rating of pin 7 (SB) of the accessory connector cable(KCT-19) on the rear of the radio is 13.6V (1A). Insert a 1Afuse if you use the SB pin for external equipment.Accessory connectorcable (KCT-19)If you do not intend to use the 3.5-mm jack for the exter-nal speaker, fit the supplied speaker-jack cap (B09-0235-05)to stop dust and sand getting in.13+–761315Merchandise receivedLicense and frequency allocated by FCCChoose the type of transceiverDeliveryTransceiver programming (Option)KAP-1PA/HA unitKES-3External speakerKCT-19Accessory connector cableKCT-18Ignition sense cableFrequency range (MHz)450~490RF power25WTypeKSee page 10.A personal computer (IBM PC or compatible), programming interface (KPG-46),and programming software (KPG-76D) are required for programming.(The frequency and signalling (option) data are programmed for the transceiver.)KCT-35Connection cableKGP-2A ModemGPS receiver orKGP-2B ModemGPS controllerKGP-1A ModemGPS receiver orKGP-1B ModemGPS controllerSee page 12.See page 17. See page 13.See page 14.(Option)(Option)KES-4External speakerSee page 17.(Option)(Option)(Option)(Option)(Option)KCT-20Connection cable(Option)(Option)SYSTEM SET-UP