3IntroductionBefore you begin, you will need to have a copy of KPG-49D and programming cableavailable to program the mobile radio. Also, you will need a copy of the Pyramid 2012programming software and FY-1 programming cable to program the 2012.Your TK-x80 radio MUST be programmed with firmware version 8050 or newerfor mobile data applications. To get a copy of version 8050 firmware please contactyour Kenwood dealer.Programming the Pyramid 2012/MerlinThe mobile data terminal needs to be programmed to accommodate the polarities ofsignal that the Kenwood mobile will provide it.If you have not already done so, install the programming software on to your PC byfollowing the instructions in the 2012/Merlin service manual.Start running the Pyramid 2012/Merlin programming software on your PC. From theData pull down menu, under the System Data screen, program the unit as shown thefigure below.+----------------------------- +¦ ¦¦ Vehicle #: 100 (000 -999) ¦¦ Base #: 1 (1-4) ¦¦ ¦¦ PTT Delay: 0.5 S (.1 -2.5) ¦¦ Retries: 3 (0-9) ¦¦ ¦¦ Trunking mobile Yes ¦¦ Sequential Status No ¦¦ ANI on mobile PTT No ¦¦ Enable Time Stamp No ¦¦ ¦¦ COR Polarity High ¦¦ On Air Polarity High ¦¦ I/O Pin 9 Output Mute ¦¦ ¦¦ ¦+----------------------------- +From the Data pull down menu, select your Data Format in the Format Screen. Thereare three signaling format cho ices. Chose the format to fit your application.More programming instructions are available in the 2012/Merlin Service Manual.Vehicle # and Base # willvary with your application.Note: Console needs tomatch programming the2016 Console Software.Enable Turnking Mode ifapplicable.Set COR and On AirPolarity to High.