Kenwood TKR-751 Modification Information Manual pdf 17 page image
Manuals database logo
manualsdatabase
Your AI-powered manual search engine

Kenwood TKR-751 Modification Information

Also see for TKR-750: Brochure & specsService manualService manualFunction referenceService manual

Page 1 previewPage 2 previewPage 3 previewPage 4 previewPage 5 previewPage 6 previewPage 7 previewPage 8 previewPage 9 previewPage 10 previewPage 11 previewPage 12 previewPage 13 previewPage 14 previewPage 15 previewPage 16 previewPage 17 previewPage 18 preview
Contents
  1. Table Of Contents
  2. TERMINAL FUNCTION
  3. pin Connector
  4. terminal function
  5. pin Connector (CN601)
  6. MODIFICATION OF THE ANTENNA
  7. INSTALLING THE VOICE SCRAMBLER BOARD
  8. Installing the SC20-460
  9. Configuration with the Software
  10. MODIFYING THE DC POWER
  11. EXTRACTING RSSI SIGNAL FROM THE ACC 25-PIN D-SUB CONNECTOR
Kenwood TKR-751 Modification Information Manual pdf 17 page image
Version: 1.02 USA Modification Information (MOD) 124 MODIFYING THE DC POWERIt is possible to modify the DC power to prevent the TKR-750/858/751/851 is turned ON with the erroneousoperation of the power switch. With this modification, theDC power is always turned ON regardless of the powerswitch operation.Follow the procedures below to modify the DC power.It must turn the power OFF before DC power modification.1. Remove the front side top panel.Remove 6 screws (N33-3006-45, 3 mm diameter,black) and pull the TX-RX PANEL up.2. Solder the PSW part located on the left side of the TX-RX unit (A/2) to make a soldering bridge.3. Reassemble the repeater after modifying the DCpower.TX-RX unit (A/2)Solder here to bridge.
/ 18
Related manuals for Kenwood TKR-750
Kenwood TM-261A Instruction Manual first page preview
Kenwood TM-261A Instruction Manual
Kenwood TK-190 Service Manual first page preview
Kenwood TK-190 Service Manual
This manual is suitable for:
TKR-750TKR-751TKR-850TKR-851
Manuals database logo
manualsdatabase
Your AI-powered manual search engine