Kenwood VR-6050 Instruction Manual

Also see for KRF-V6060D: Instruction manual Service manual Service manual

Contents

Kenwood VR-6050 Instruction Manual Manual pdf 21 page image

Normal playbackPreparing for playback Listening to a source componentSome prepaiatoty steps are needed before stamng playbackVOLUME CONTROLPOWERION/STANDBY 0ON/STANDBY 0 (KRF4’7060DN6060D)(VR-6050)A SPEAKERS 0 INPUT MODEPOWER ON/OFF MD/TAPE(KRF-V7060DN6060D)Turning on the receiver0 Turn on the power to the related components.0 Turn on the power to this receiver by pressing the POWERON/STANDBY L!I (for VR-60501 key or POWER ON/OFF andON/STANDBY ti (for KRF-V7060D/V6060D) key.Selecting the input modeIf you have selected a component connected to the CD/DVD, VIDEO 2oi DVD/GCH jacks, make sure that the input mode setting IS correct folthe type of audio sIgnal to be used -;$Selecting MD/TAPESelect the source name corresponding to the component connected tothe MDflAPE lacks The lnltial factory setting IS “TAPE” To change thesource to “MD”, follow the steps below.Hold down the MD/TAPE key for more than 2 seconds.l The so~irce Indlcatlon changes to “MD”l To return to the orIgInal Indlcatlon, repeat the above procedureSelecting the speaker systemPress the A SPEAKERS B key to select the speaker system to beused.AON : Sound ftom the speakers connected to the SPEAKERS Atennlnals on the rear panelBON : Sound from the speakers connected to the SPEAKERS Btelmmals on the rear panel No sound WIII be heard fromihe subwooferA+B ON : Sound from both the speakers connected to theSPEAKERS A and B terminals on the rear panelA+B OFF : No sound from the speakers Use this setting whenIIstenlng witi? headphones for stereo sound in all playbackImodes. The display segments are different depending 01~rhe type of input signalThe lndlcator for the speakersyowlwaist to use should be Ilt.Input Selector AV AUXVOLUME +I-INPUT SELECTOR0 Use the /nput Selector and AVAUX keys to select thesource you want to listen to.Selecting a source using each key.VR-6050/KRF-V7060D/V606OD1 “DVD/GCH”2 “CDIDVD”3 “AUX” or “PHONO” (for KRF-V7060D only)4 “TUNER”5 “VIDEO 1”6 “VIDEO 2”i “VIDEO 3”8 “MD/TAPE”9 “AV AUX”KRF-V6060D (for the U.K. only)1 “DVD/GCH”2 “CDIDVD”3 “PHONO”4 “TUNER”5 “VIDEO 1”6 “VIDEO 2”7 “VIDEO 3”8 “MD/TAPE”9 “AV AUX”q Start playback from the selected source.B Use the VOLUME CONTROL knob or VOLUME +/- keys toadjust the volume.0 Selecting “6CH INPUT” by pressing the INPUT MODE key, whereby“DVDIGCH” IStile Input source WIII cause SPEAKERS A to be selectedautomatically21 EN