Kenwood VR-6070 Instruction Manual

Also see for VR-6070: Service manual Service manual Instruction manual Instruction manual Instruction manual

33 ENThe remote control supplied with this receiver is also capableof controlling components from a variety of manufacturersonce you register the appropriate setup codes into theremote control unit.Registering setup codes for other components1 Find the setup code of the component to be registered.• Refer to the setup code lists to find the setup code for thecomponent to be registered. fiExample: To register a DVD made by KENWOOD, you would enter“0534”.Input Component Maker Code Key(DVD) DVD player KENWOOD 0534 DVDSource key Other componentsTUNER Receiver (Kenwood)DVD/6CH DVD (other manufacturers')CD/DVD CD and MD (Kenwood)MD/Tape Cassette deck (Kenwood)VID1 / AV AUX VCR and PVR (other manufacturers')VID2 Cable and DTV decoder (othermanufacturers')VID3 DSS (other manufacturers')PHONO Additional key for re-assigningTV TV/VCR combo, TV/DVD combo, TV(other manufacturers')2Press the source keys (DVD/6CH, CD/DVD, VID1, VID2, VID3,TV, MD/TAPE, AV AUX, PHONO). 7• PHONO key has to re-assigned to another key before a setupcode can be registered. ›• While in Tuner mode, setup code function will not be available.3Press and hold the Remote Setup key until the LED blinkstwice, then release the Remote Setup key.4Press the numeric key to enter the four-digit code for thecomponent to be registered.• If performed correctly, the LED will blink twice.• Point the remote control at the component and press SRC Powerkey once. It should turn on/off but if it does not, repeat step 2 to 4• If the component still does not work, try searching for the code.5Repeat steps 2to 3to register additional components untilall components have been registered.NoteAlthough each setup code is designed to work with a number ofdifferent models, certain codes may not work with some models.(Also, certain codes may only operate some of the functions availableon a given model.)Searching for your codesIf you component does not respond after trying all the codes listed foryour component, or if your component is not listed at all, try searchingfor your code.For example, to search for code for your TV:1Press the TV key once. Next, press and hold the Remote Setupkey until the LED blinks twice, then release the Remote Setupkey.2Press the numeric key to enter "9 - 9 - 1".• The LED will blink twice.3Point the remote control at the TV and slowly alternatebetween pressing the SRC Power and TV keys.• Stop when the TV turns on or off.• In the search mode, the remote control will send IR codes from itslibrary to the selected device, starting with the most popular codefirst.4Press the Remote Setup key once to lock in the code.5To search for the codes of your other components, repeatsteps 1through 4, but substitute the appropriate key (i.e.,DVD/6CH, CD/DVD, VID1, VID2, VID3, TV, MD/TAPE, AV AUX,PHONO).• PHONO key has to be re-assigned to another key before a setupcode can be programmed.Basic remote control operations for other componentsLow battery warningReplace all two batteries with new ones when you notice a shorteningof the distance from which the remote control will operate.Theremote control is designed to retain setup codes in memory whileyou change batteries.SRC PowerNumeric keysSourcekeysLEDRemoteSetup