Kenwood VRS-5100 Instruction Manual

Also see for VRS-5100: Service manual

4 ENBefore applying the powerOperationWhen the STANDBY indicator is lit, the power turns ON when you pressthe POWER key on the remote control. When the power comes ON,press the key you want to operate.• When pressing more than one remote control key successively,press the keys securely by leaving an interval of 1 second or morebetween keys.Notes1. The supplied batteries may have shorter lives than ordinary batteriesdue to use during operation checks.2. When the remote-controllable distance gets shorter than before,replace both batteries with new ones.3. Placing the remote sensor in direct sunlight, or in direct light from ahigh frequency fluorescent lamp may cause a malfunction.In such a case, change the location of the system installation toprevent malfunction.Preparing the remote controlLoading the batteries1 Remove the cover. 2 Insert the batteries.3 Close the cover.• Insert two AAA-size (R03) batteries as indicated by the polaritymarkings.Operating range(Approx.) Remote sensorInfrared ray systemUnpackingUnpack the unit carefully and make sure that all accessories arepresent.FM indoor antenna (1) AM loop antenna (1)Remote control unit (1) Batteries (R03/AAA) (2)RC-R0516E (for the Europe)RC-R0516 (except for the Europe)FM antenna adapter (1)If any accessories are missing, or if the unit is damaged or fails to operate,notify your dealer immediately. If your unit was shipped to you directly,notify your shipper immediately. Kenwood recommend that you retainthe original carton and packing materials in case you needs to move orship the unit in the future.Keep this manual handy for future reference.Channel space switching(Except for the Europe and Australia)The space between radio channels has been set to the one thatprevails in the area to which the system is shipped. However, if thecurrent channel space setting does not match the setting in the areawhere the system is to be used, for instance when you move fromarea 1 or area 2 shown in the following table or vice versa, properreception of AM/FM broadcasts cannot be expected. In this case,change the channel space setting in accordance with your area byreferring to the following table.Turn the power OFF by pressing the POWER key before moving theswitch level. Move the switch lever to match your area with a smallscrewdriver or other pointed tool, then turn the power ON again.1.2.CHANNELSpace FrequencyAreaU.S.A., Canada and SouthAmerican countriesOther countriesFM: 100 kHzAM: 10 kHzFM: 50 kHzAM: 9 kHzFM75ΩAMGNDSURR BACK/SW REAR FRONTCENTER LRLRSPEAKERS (6 – 16Ω)ANTENNAVIDEO1VIDEO2DVD SUB WOOFERSURR BACKPREOUTLR LRIN OUTAUDIOVIDEO2INDVDINS VIDEO VIDEOMONITOROUTMONITOROUTVIDEO1IN OUTCOAXIALOPTICALVIDEO1VIDEO2DVDDIGITAL INVOLTAGE SELECTORAC110-120V~AC 110-120V/220-240V~50/60HzWAC220-240V~ DE-EMPHASISCHANNEL SPACE50μsAM9kHzFM50kHz75μsAM10kHzFM100kHzR /LBSDE-EMPHASISCHANNEL SPACE50μsAM9kHzFM50kHz75μsAM10kHzFM100kHz