Kenwood XD-A950DV Instruction Manual

Also see for XD-A850DV: Instruction manual

Contents

Kenwood XD-A950DV Instruction Manual Manual pdf 2 page image

2PreparationsXD-DV series (EN/K,M,T,X,Y)/2CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVECOVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SER-VICING TO QUALIFIED SERVICE PERSONNEL.THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRI-ANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DAN-GEROUS VOLTAGE” WITHIN THE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENTMAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERTTHE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SER-VICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE.Units are designed for operation as follows.Safety precautionsFactory fitted moulded mains plug1. The mains plug contains a fuse. For replacement, use onlya 3-Amp ASTA-approved (BS 1362) fuse.2. The fuse cover must be refitted when replacing the fuse inthe moulded plug.3. Do not cut off the mains plug from this equipment. If theplug fitted is not suitable for the power points in your homeor the cable is too short to reach.A power point, then obtain an appropriate safety approvedextension lead or adapter, or consult your dealer. If none-theless the mains plug is cut off, remove the fuse anddispose of the plug immediately, to avoid a possible shockhazard by inadvertent.Connection to the mains supply.IMPORTANT :The wires in the mains lead are coloured in accordancewith the following code:Blue : NeutralBrown : LiveDo not connect those leads to the earth terminal of a three-pin plug.For the United KingdomWARNING :TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THISAPPLIANCE TO RAIN OR MOISTURE.The marking is located on the rear panel and says thatthe component uses laser beams that have been clas-sified as Class 1. It means that the unit is utilizing laserbeams that are of a weaker class. There is no danger ofhazardous radiation outside the unit.CLASS 1LASER PRODUCTThe marking of products using lasers(Except for some areas)U.S.A. and Canada ...................................................... AC 120 V onlyEurope and U.K. ........................................................... AC 230 V onlyAC voltage selectionThe AC voltage selector switch on the rear panel is set to thevoltage that prevails in the area to which the unit is shipped.Before connecting the power cord to your AC outlet, makesure that the setting position of these switches matches yourline voltage. If not, it must be set to your voltage in accordancewith the following direction.*For other countriesAC voltage selector switchesMove switch lever to match your line voltage with a smallscrewdriver or other pointed tool.Note:Our warranty does not cover damage caused by excessive linevoltage due to improper setting of the AC voltage selectorswitch.Before applying power Caution : Read this section carefully to ensure safe operation.IntroductionCaution : Read this section carefully to ensure safe operation.CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENAC 110-120VAC 220-240VAustralia ....................................................................... AC 240 V only*Other countries .................... AC 110-120 / 220-240 V switchable