Kenwood krf v5080d Instruction Manual

Also see for krf v5080d: Instruction manual Instruction manual Service manual

15 ENSetting up the systemConnecting the terminalsSpeaker impedanceAfter confirming the speaker impedance indications printed on therear panel of this model, connect speakers with matching impedanceratings. Using speakers with a rated impedance other than thatindicated on the rear panel of this model could result in malfunctionsor damage to the speakers or this model.• Never short circuit the + and – speaker cords.• If the left and right speakers are connected inversely or the speakercords are connected with reversed polarity, the sound will beunnatural with ambiguous acoustic imaging. Be sure to connect thespeakers correctly.Speaker placement* For Surround Back speaker, you may place either two SurroundBack speakers (Surround Back Left speaker and Surround BackRight speaker) for 7.1 channel surround sound system or oneSurround Back speaker for 6.1 channel surround sound system.Front speakers : Place to the front left and right of the listeningposition. Front speakers are required for all surround modes.Center speaker : Place front and center. This speaker stabilizes thesound image and helps recreate sound motion. Required for surroundplayback.Surround speakers : Place to the direct left and right, or slightlybehind, the listening position at even heights, approximately 1 meterabove the ears of the listeners. These speakers recreate soundmotion and atmosphere. Required for surround playback.Subwoofer : Reproduces powerful deep bass sounds.Surround Back speaker/s : Place the speaker/s directly at the rearof the listening position. The optimum position depends mainly on theroom condition.• Although the ideal surround system consists of all the speakerslisted above, if you don't have a center speaker or a subwoofer, youcan divide those signals between the available speakers in thespeaker settings steps to obtain the best possible surroundreproduction from the speakers you have available. ^GNDAM FM75ΩANTENNAConnecting the antennasAM loop antennaThe supplied loop antenna is for use indoors. Place it as far as possiblefrom this model, TV set, speaker cords and power cord, and adjust thedirection for best reception.FM indoor antennaThe supplied indoor antenna is for temporary use only. For stablesignal reception we recommend using an outdoor antenna. Disconnectthe indoor antenna when you connect one outdoors.FM outdoor antennaLead the 75Ω coaxial cable connected to the FM outdoor antenna intothe room and connect it to the FM 75Ω terminal.AM antenna terminal connections1 Push lever. 2 Insert cord. 3 Release lever.FM antenna terminal connectionsInsert the connector.Use an antennaadapter(Commerciallyavailable)Attach to thestandAM loop antennaFM indoor antennaFM outdoor antennaFrontspeakerSubwooferCenter speakerListeningposition*SurroundBack speakerSurroundspeaker*SurroundBack Leftspeaker*SurroundBack Rightspeaker*Optional in this model.3 Insert the cord. 4 Return the lever.2 Push the lever1 Strip coating.KRF-V5080D VR-806VR-806KRF-V5080D