Keysight Technologies E5092A Installation Manual

Keysight Technologies E5092A Installation Manual Manual pdf 21 page image

Keysight E5092A Configurable Multiport Test Set 21InstallationStarting up E5092AStarting up E5092AThis section describes how to turn ON/OFF the E5092A and how to cut thesupply of power in an emergency.Turning ON/OFF the powerTurning ON powerStep 1. Check that the line switch in the lower left part of the front panel is pulled up( ). If it is pushed in ( ) which means the power is OFF, push thestandby switch to pull it up ( ).Step 2. Push the line switch to push it in ( ).Turning OFF powerTo turn OFF the E5092A, do the following.• Push the line switch in the lower left part of the front panel so that theswitch pushed in ( ) is pulled up ( ).Cutting supply of powerFor the E5092A, the disconnecting device (the device to cut the supply ofpower) is the plug of the power cable (on the power outlet side or the E5092Aside).If you need to cut the supply of power to avoid danger of electric shocks,disconnect the plug of the power cable (on the power outlet side or theE5092A side).To turn OFF the E5092A in normal times, press the line switch. In normaltimes, never disconnect the power cable to cut the supply of power to thepower cable receptacle on the rear panel.Follow the description in “Providing space to disconnect the plug of thepower cable” on page 15 so that you can perform this operation reliably.To turn OFF the power in normal times, be sure to follow the procedure in“Turning OFF power”.