Keysight Technologies FieldFox N9913A Configuration Manual

Also see for FieldFox N9913A: User guide Security features and volatility documentation Service guide

Contents

Keysight Technologies FieldFox N9913A Configuration Manual Manual pdf 11 page image

11 | Keysight | FieldFox Handheld Analyzers - Configuration GuideFieldFox Microwave Vector Network Analyzer FAQsQuestion Answer1. What is included with a baseN992xA analyzer?– Measurements: Transmission/reflection or S21 and S11, magnitude and phase– Calibrations: CalReady, OSL, response, and enhanced response cal2. What is included with N992xAOption 211?– Option 211 adds full 2-port S-parameter capability– Measurements: All four S-parameters (S11, S21, S22, S12), magnitude and phase– Calibrations: CalReady, OSL, response, enhanced response, and full 2-port cal3. What is included with N992xAOption 010?– S11/S21 in time domain. To get time domain data for all four S-parameters and full 2-port cal, order Option 211– View both time and frequency domain data at the same time– Low-pass, impulse, and band-pass modes– Minimum, normal, and maximum window– Gating4. What is included with N992xAOption 305?– Measurements: DTF (dB, linear, VSWR), return loss and DTF, return loss (dB), and 1-port cable loss, 2-portinsertion loss– TDR (linear, ohm). TDR measurements require Option 215, in addition to Option 305.– Calibrations: CalReady, OSL, and response cal5. What is included with N992xAOption 308?– N992xA with Option 308: 1-port cable trimming, 2-port transmission– N992xA with Options 308 and 211: 1-port cable trimming, 2-port transmission, A/B and B/A– Note: A/B and B/A measurements require an external source6. If I have the full 2-port VNA withtime domain, why would I orderOption 305? What additionalfunctionality is available?CAT mode’s basic measurements are similar to VNA measurements. The features listed below are often used fordistance-to-fault cable testing and are only available in CAT mode:– 3-peak marker tracking for finding faults for DTF measurements– 1-port cable loss– Cable type selection and editing, includes the cable’s velocity factor and loss7. What is included with N992xAOption 112?– QuickCal is included with Option 112.– 1-port and enhanced response QuickCal with a base analyzer– 1-port, enhanced response, and 2-port QuickCal with a full 2-port analyzer (one that has Option 211).– QuickCal is most accurate for DUTs with 7/16 and Type-N connectors and measurement uncertainties areprovided for frequencies 18 GHz. Reduced accuracy for DUTs with 3.5 mm (m), SMA (m), or other male coaxialconnectors; performance is unspecified. QuickCal is not recommended for DUTs with 3.5 mm (f), SMA (f), orother similar female connectors. QuickCal is not applicable to waveguide.Additional FAQs on pages 8 and 9. FAQs on pages 8 and 9 apply to all microwave FieldFox models.