Keysight Technologies InfiniVision 6000L Series Service Manual

Also see for InfiniVision 6000L Series: User guide

Contents

30 6000L Series Oscilloscopes Service Guide2 Testing Performancec Press the Acquire key. Then press the Averaging softkey and set #Avgs to 64.Wait a few seconds for the measurement to settle.2 Press the Cursors key, set the Mode softkey to Normal, then press the X Y softkeyand select Y. Press the Y1 softkey, then use the Entry knob (labeled on thefront panel) to set the Y1 cursor on the baseline of the signal.3 Use the BNC tee and cables to connect the oscilloscope calibrator /powersupply to both the oscilloscope and the multimeter (see Figure 3).Table 7 Settings Used to Verify Voltage Measurement AccuracyVolts/Div Setting Oscilloscope CalibratorSettingTest Limits5 V/Div 35 V 34.04 V to 35.96 V2 V/Div 14 V 13.616 V to 14.384 V1 V/Div 7 V 6.808 V to 7.192 V500 mV/Div 3.5 V 3.404 V to 3.596 V200 mV/Div 1.4 V 1.3616 V to 1.4384 V100 mV/Div 700 mV 680.8 mV to 719.2 mV50 mV/Div 350 mV 340.4 mV to 359.6 mV20 mV/Div 140 mV 136.16 mV to 143.84 mV10 mV/Div 70 mV 68.08 mV to 71.92 mV5 mV/Div 35 mV 34.04 mV to 35.96 mV2 mV/Div 1 (for 1 GHz and 500 MHz models)14 mV 13.232 mV to 14.768 mV2 mV/Div (for 100 MHz models)14 mV 13.616 mV to 14.384 mV1 mV/Div 2 7 mV 6.616 mV to 7.384 mV1 Full scale is defined as 32 mV on the 2 mV/div range for 500 MHz and 1 GHz models.2 Full scale is defined as 16 mV on the 1 mV/div range for 100 MHz models.Full scale on all other ranges is defined as 8 divisions times the V/div setting.