Kiramek 1460 series Owner's Manual
                                            | |
VISION 1460 OWNER’S GUIDE3Arming & disarmingARMINGCONFIRMATION CHIRPSNORMAL ARMINGClose all doors and then LOCK by your factorykeyless remote or by SmartKey door handletouch. Hazard lights will flash, doors will lock, andthe siren will chirp 1 time (if Confirmation Chirps areON). The Status LED will light for 5s, during whichtime all triggers are disabled. Then the Status LEDwill start flashing and Ignition, Door, Trunk and Hoodtriggers become enabled. The Shock Sensor (and any other external sen-sor) is enabled 5s after the LED starts flashing (10s after you Lock).SENSOR BYPASS ARMINGThis procedure lets you temporarily disablethe Shock Sensor for a single Arming session:1) With Ignition OFF, press the Program Switch twice.2) Within 20s, press LOCK on the factory remote to Arm.The system is now Armed in Sensor Bypass Mode, and all triggers are activeexcept the shock sensor and any other external sensors. Note that when youDisarm and then Arm again normally, the shock sensor will be enabled.(ON by default)This procedure lets you enable or disable theArm/Disarm chirps. (Note that the siren willstill go off when the 1460 is triggered.)1) With Ignition OFF, press the Program Switch once.2) Within 20s, press LOCK on the factory remote to Arm.The confirmation chirp state has now toggled and the system is Armed. Re-peat the above procedure to toggle the confirmation chirp state back again.PROGRAMMABLEOFFOFFLOCK2 Pushes1 Push |
Related manuals for Kiramek 1460 series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine