Kiramek Vision 1014C Instruction Manual
                                        | |
Contents
| 
8MAIN HARNESSThis wire is the main (–) ground input to the 1014. Be sure to connect thiswire securely to a good ground source. Most security system installationproblems result from a bad ground connection!Find a piece of bare metal on the vehicle and use some steel wool to clean itoff before you make your connection. Determine the length of wire needed,and cut the black wire shorter if necessary. Crimp on the included ringconnector. Screw down your connection tightly.H1H1-BLK (–) System GROUNDThis wire is the main (+) 12v power input to the 1014. Be sure to connectthis wire securely to a constant 12v source, but connect this wire last so thesiren doesn’t go off.If you cannot find a constant 12-volt source under the dash, you may needto run a wire directly to the positive battery terminal in the engine compar-ment. If you need to extend this 12v power wire, use wire thicker than theRED wire. Do not bypass the fuse on the RED wire. If you blow the fuse,replace with a 15A blade type.H1-RED (+) System POWERThis cream-colored 4-pin connector is to be attached to the included 318-052 shock sensor, as shown in the diagram on page 7. Optional sensors(such as VISION RSA-series field sensors or the 318-022 digital tilt sensor)can be easily added to this line with the purchase of an optional 318-035Sensor Splitter.H1-4 pin Shock Sensor ConnectorThis white 3-pin connector can be attached to the included 318-04 ultrason-ic sensor, as shown in the diagram on page 7. Be sure to keep the controlunit of the Ultrasonic sensor more than 30cm (1ft) away from the body ofthe 318-052 shock sensor to avoid interference and possible false alarms.H1-3 pin Ultrasonic Sensor ConnectorINSTALLATION |
Related manuals for Kiramek Vision 1014C
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine