Kiramek Vision 1014C Instruction Manual
                                        | |
Contents
| 
VISION 1014C INSTRUCTION MANUAL25FEATURE PROGRAMMINGTo program features, have your vehicle’s key ready to turn theignition (IG) “on-and-off” several times. (TIP: Use the “ACC” posi-tion as IG “off” because its easier to switch.) Perform the following3-step procedure to alter the features shown in Table-1 below:Disarm1. the system. (Or “Arm-then-Disarm” if repeating this procedure.)Turn2. IG on-and-off the same number of times as the feature you wish toprogram (refer to “No.” in Table-1 below), within 20 sec. of disarming.(For example, if you want to change “Auto Arm,” you must turn the IGon-and-off 8 times within 20 sec.)Push3. Button-1 on the transmitter. (Your chosen setting has toggled.The Status LED will then flash the same number of times as the featureyou just programmed.)When the Status LED stops flashing in Step-3 above, you may program•another feature by restarting this procedure at Step-1.NOTES: (1) After you program a feature, the Status LED will flash the samenumber of times as the feature you just programmed, but there will be no in-dication of the “setting” you just toggled to—simply test your 1014 system toconfirm your programming. (2) There is no “reset to factory default” feature.TABLE-1 Feature Selection MenuNo. Feature Description Toggle Settings3 IG Protect Mode / Remote Start C. Mode IG Protect RSCM4 Vehicle Lights ON During Remote Start OFF ON8 Auto Arm OFF ON9 Exit Delay Time Selection 3 sec. 15 min.10 Auto Rearm OFF ON13 IIP Trigger Selection All Door17 Exterior Illumination OFF ON20 Transmitter Learning / Force Reset Code Default Reset Code = 6FACTORY DEFAULT SETTINGS SHOWN IN BOLD TEXT ABOVE |
Related manuals for Kiramek Vision 1014C
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine