L-Acoustics SB18 Rigging Manual

Also see for KIVA SB18: Owner's manual Owner's manual Rigging manual Owner's manual User manual

Contents

L-Acoustics SB18 Rigging Manual Manual pdf 13 page image

SB18_RM_EN_1-0 w w w . l - a c o u s t i c s . c o m 13131313D. Preparing the KARA-MINIBU flying structureRequired materialElectric screwdriver with torque selector, 6 mm hex bit, 13 mm hex key Attach two KARA-MINIBUEX to the KARA-MINIBU.a. Place a KARA-MINIBU at the rigging location with the identification plate right-side up;b. On each side, install one KARA-MINIBUEX, with feet up, by inserting one of its stud into a KARA-MINIBU slit;c. Secure the assembly by driving 3 bolts on each side (6 mm hex bit, 13 mm hex key, 7 N.m/63 in.lbf).Orientation of the KARA-MINIBU frameThe KARA-MINIBU frame is symmetrical so that the installation as a front or rear extension can beachieved wherever the KARA-MINIBUEX are installed. However, it is recommended at this step toanticipate the front or rear extension so as to keep the laser plate at the front of the array. Attach the shackle(s) to the KARA-MINIBU, in the hole(s) corresponding to the chosen flying option and providingthe desired site angle (see modeling in SOUNDVISION and APPENDIX B). If needed, install a laser device on the laser plate (see APPENDIX C). PROCEDURE D : Preparing the KARA-MINIBU flying structureb A MINIBUEX stud being insertedinto a KARA-MINIBU stud c The MINIBUEX/KARA-MINIBU assembly being securedon one side with 3 hex screws (M8 x 25 mm) and 3 nutsA Ø12mm bow shacklebeing attached A CLAMP250being attached END The KARA-MINIBU flying structure ready(Option 4, see APPENDIX B)