L-Acoustics SB18 Rigging Manual
Also see for KIVA SB18: Owner's manualOwner's manualRigging manualOwner's manualUser manual
                  | |
SB18_RM_EN_1-0 w w w . l - a c o u s t i c s . c o m 17171717APPENDIXAPPENDIXAPPENDIXAPPENDIX CCCC:::: INSTALLING THE LAP-TEQ INCLINOMETERA laser support plate has been integrated to the M-BUMP and the KARA-MINIBU for the optional installation of theTEQSAS® LAP-TEQ inclinometer. The LAP-TEQ is a remote control device which is part of the L-ACOUSTICS®TECH TOOLCASE.LAP-TEQ inclinometer installed on the M-BUMP (left) or the KARA-MINIBU (right)Required materialElectric screwdriver with torque selector, T20 Torx® bit, 7 mm hex key Put the M-BUMP or KARA-MINIBU with identification plate right-side up. Undo the four Torx® bolts on the laser support plate (T20 bit, 7 mm hex key). Place the LAP-TEQ on the laser support plate with laser lens towards the front laser slit, verifying nothing obstructsthe slit opening. Drive the four Torx® bolts into the holes of the inclinometer and the plate (T20 bit, 7 mm hex key, 3 N.m/27 in.lbf).APPENDIX D:APPENDIX D:APPENDIX D:APPENDIX D: SAFETY PIN MECHANISM ON SHACKLESCalibrating the LAP-TEQRefer to the manufacturer instructions in the L-ACOUSTICS® TECH TOOLCASE. In addition to thehandheld inclinometer available in the TOOLCASE, an XLR3 cable is needed.Securing the shackleALWAYS put the safety pin in locked position to secure an assemblyUnlockLock |
Related manuals for L-Acoustics KIVA SB18
L-Acoustics SB18i Rigging Manual
L-Acoustics SB18m Rigging Manual
L-Acoustics SB15m Rigging Manual
L-Acoustics SB28 Rigging Manual
L-Acoustics SB18 User Manual
L-Acoustics SB18 User Manual
L-Acoustics SB118 User Manual
L-Acoustics SB118 User Manual
L-Acoustics SB18 IIi Owner's Manual
L-Acoustics SB15m User Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine