L.B. White I17 Owner's Manual And Installation Instructions

Also see for I17: Owner's manual and instructions Owner's manual and instructions Owner's manual and instructions Owner's manual and instructions Assembly and installation instructions

L.B. White I17 Owner's Manual And Installation Instructions Manual pdf 17 page image

16BOOT IGNITORABSCREWSCOVERCIGNITER/FLAME SENSOR1. Disconnect the heater from its electrical supply.2. Close fuel supply valves to heater.3. Pull the boot of the ignition lead up and back from theigniter along the lead to expose the igniter to ignitionlead terminal. If the ignition cable terminaldisconnects as the boot is being pulled back, use aneedle nose pliers to retrieve the terminal and pull itback through the igniter end of the boot. See Fig. 11.4. Disconnect the lead from the igniter.5. Remove the screws which secure the igniter and it’smounting cover to the heater top.6. Remove the igniter from the heater. The igniter rodand its insulating ceramic body must be rigid withinits mounting bracket. If the igniter rod or its body arecapable of movement, the igniter will not be properlypositioned to the combustion cone. The igniter mustthen be replaced.7. Clean the igniter rod with steel wool or emery cloth.8. Reattach the igniter and the cover into the heater top.Tighten Securely.9. Restar t the heater according to the star t upinstructions on page 11.FIG. 111/8" TO 3/16" GAPBETWEEN ELECTRODE AND CONEFIG. 12.100 TO .200 GAPBETWEEN ELECTRODE AND CONEATTENTION■ To adjust igniter gap, remove outer combustion cone.■ Use pliers to support the igniter rod near ceramicinsulator.■ Carefully bend electrode to achieve proper ignitiongap. See Fig. 12.