8Installation and Assembly InstructionsASSEMBLYTOOLS REQUIREDCP075EK- Medium Phillips screwdriver.1.on the upper housing.2. Remove the pre-assembled screws on the shell upper and side cover.3. Align the holes in upper housing with two mounting holes on the handle as shown in Figure 4.4. Secure handle with screws removed.5. Insert cord wrap into the rectangle holes on the supporter and align the hole on the cord wrap withthe mounting hole on the side covers shown in Figure 4.6. Secure cord wrap with screws removed.CP125FK/CP175FK/CP210FK- Medium Phillips screwdriver.- M5 open, or adjustable wrench.1. Slide threaded axle through the rear section of the wheel support frame.2. Slide one axle bushing on to each side of the axle. Slide one wheel on to each side of the axle.3. Attach one cap nut on to each side of the threaded axle and tighten well.4. Place heater on wheel support frame. Make sure the air inlet end (rear) of heater is over wheels. Align the holes on fuel5.6. Align the hole on the handle (front and rear) with the mounting hole on the cord wrap.7.8.Handle Cord WrapsCord WrapsWheelsScrewsScrewScrewSide CoverCord WrapUpper ShellSlit HoleWedged PortionFront GuardFrontHandleRearHandleWheel Support FrameAxleHandleRemove ScrewsRemove ScrewsNutsFlange ScrewsCap Nuts S Cap Nuts LBushingsFigure 4 - Handle and Cord Wrap Installation CP075EKModel CP075EK CP125FK CP175FK CP210FKWheel Support Frame No Yes Yes YesWheels No Yes Yes YesFront-Handle No Yes Yes YesRear-Handle No Yes Yes YesAxle No Yes Yes YesCord Wrap Yes Yes Yes YesHardware Kit No Yes Yes YesHandle Yes No No NoWARNINGFire or explosion hazard!- Do not operate heater without supportframe fully assembled to tank.CP075EK ModelCP125FK/CP175FK/CP210FK Models